SCANIA SDP3 2.35 Diagnostic & Programmer + Activation without Dongle

Scania SDP3 2.35 Diagnostic & Programmer

Scania Diagnos & Programmer 3 (SDP3) communicates with Scania vehicles and Scania industrial and marine engines. The program has been developed to support the electrical system with CAN communication.

The program is used for troubleshooting, adjusting customer parameters, calibrations, conversions affecting the electrical system and updating software in control units.

Scania diagnostic software works with VCI 2 interface

Highest level access
Internal Scania
Industry & Marine
Authorized Scania Workshops
Bodybuilder

Scania SDP3 Features:

Check and adjustements
Conversion
Maintenance
Campaign
Bodywork
Fault Codes
Fault Reporting
Programming of Control units

 

Need Netframework 4.5 installed on system. windows 7 or 8 will be better (x64 or x86 bits).
In order to install SDP3, administrator rights are required.
Note:The USB key and VCI must not be connected to the computer during the installation of SDP3, especially not if SDP3 is installed for the first time.
The communication problems related to Windows 8 is now solved. Some problem solving reconfigurations was made Thursday the 16th of October.

 

Supported languages: English, German, Spanish, French, Japanese, Dutch, Persian, Polish, Portuguese, Swedish, Norwegian, Suomi, Turkish, Italian, Czech, Russian, Chinese.

 

INSTALL ONE only COMPUTER  to active by TeamViewer